Loop Guard - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
4.24

Loop Guard

This section allows the user to inspect the current Loop Guard (Loop protection) configurations,
and possibly change them as well.
Figure 4-208: Loop Guard Configuration
Table 4-181: Loop Guard Configuration Parameters
General Settings Global Configuration
Enable Loop
Guard
Transmission
Time
Shutdown Time
Port Configuration
Port
Enable
Controls whether loop guard is enabled (as a whole).
The interval between each loop guard PDU sent on each
port. valid values are 1 to 10 seconds. Default value is 5
seconds
The period (in seconds) for which a port will be kept disabled
in the event of a loop is detected (and the port action shuts
down the port).
Valid values are 0 to 604800 seconds (7 days). A value of
zero will keep a port disabled (until next device restart).
Default value is 180 seconds.
The switch port number of the port.
Controls whether loop guard is enabled on this switch port.
349