Link Aggregation Control Protocol (Lacp) Port Configuration) - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
4.19.2

Link Aggregation Control Protocol (LACP) Port Configuration)

Figure 4-152: LACP Port Configuration
Port The switch port number.
LACP Controls LACP is enabled on this switch port.
Enabled
LACP will form an aggregation when two (2) or more ports are connected to the
same partner.
Key This value, incurred by the port, ranges from 1 to 65535.
Enter "Auto" or "Specific Key" value settings in the drop-down list.
"Auto": Sets the key as appropriate by the physical link speed; 10Mb = 1,
100Mb = 2, 1Gb = 3.
"Specific": Enter a user-defined value.
Ports with the same Key value can participate in the same aggregation group,
while ports with different keys cannot.
Role The "Role" Shows the LACP activity status.
"Active" transmits LACP packets each second.
"Passive" will wait for a LACP packet from a partner (speak if spoken to).
Timeout The Timeout controls the period between BPDU transmissions.
Fast will transmit LACP packets each second, while Slow will wait for 30
seconds before sending a LACP packet.
Prio The Prio controls the priority of the port, range 1-65535.
If the LACP partner wants to form a larger group than is supported by this
device then this parameter will control which ports will be active and which ports
will be in a backup role. Lower number means greater priority.
Buttons Save:
Reset:
saved values.
Click to save changes.
Click to undo any changes made locally and revert to previously
270