Getting Started; Quick Setup Outline - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
3

Getting Started

3.1

Quick Setup Outline

To set up the M-Class models carry out the following steps:
1. Mount the device at its location (rack or desktop).
2. Install the SFP transceivers if required.
3. Connect the unit to a console and a power source.
4. Verify that the PWR (Power, or PS1,PS2)) LED is green lit.
5. Connect required cables to ports: twisted pair (Ethernet) and fiber (Ethernet SFPs).
6. Verify that the Link and Speed LEDs ports are lit according to connected ports.
7. Configure the selected device via the console if required
8. Access the installed device via one of the management options (RS232, CLI, Telnet or
Web management)
9. For a general configuration procedure please refer to the Quick Guide located at
Fibrolan Web site ( Support > Knowledgebase > Quick Guides)
Remote management requires basic IP configuration.
20