Ip Routes - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
4.3.4

IP Routes

Figure 4-5: IP Routes
Table 4-4: IP Routes Parameters
Delete
Network
Mask Length
Gateway
Next Hop VLAN
(Only for IPv6)
Buttons
Select this option to delete an existing IP route.
The destination IP network or host address of this route. Valid
format is dotted decimal notation or a valid IPv6 notation. A
default route can use the value 0.0.0.0or IPv6 :: notation.
The destination IP network or host mask, in number of bits
(prefix length). It defines how much of a network address that
must match, in order to qualify for this route. Valid values are
between 0 and 32 bits respectively 128 for IPv6 routes. Only a
default route will have a mask length of 0 (as it will match
anything).
The IP address of the IP gateway. Valid format is dotted decimal
notation for a valid IPv6 notation. Gateway and Network must be
of the same type.
The VLAN ID (VID) of the specific IPv6 interface associated with
the gateway. The given VID ranges from 1 to 4095 and will be
effective only when the corresponding IPv6 interface is valid.
If the IPv6 gateway address is link-local, it must specify the next
hop VLAN for the gateway.
If the IPv6 gateway address is not link-local, system ignores the
next hop VLAN for the gateway.
Add Route Click to add a new IP route. A maximum of 32
routes is supported.
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to
previously saved values.
29