Initial Configuration; Web Management Initial Display - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
3.2.1

Initial Configuration

This first configuration is done via the console; it enables the switch to connect to the IP network..
Once the unit IP address is set via console, the system can be accessed through Web, Telnet or any
other management options.
Initial IP setup can be implemented by manually setting the IP address Parameters or by an
automatic DHCP setup (if a DHCP server is present).
Both setup procedures may be implemented via the following CLI IP
configuration commands:
Falcon# config terminal
Falcon(config)# ip ?
example: Falcon(config)# ip routing
arp
dhcp
dns
domain
helper-address
http
igmp
multicast
name-server
route
routing
source
ssh
verify
3.2.2

Web management initial display

The Web management is accessed by setting the required IP address in the URL Browser.
When accessing the devices via the Web interface, its initial Port State Overview window is
displayed. as shown below.
Address Resolution Protocol
Dynamic Host Configuration Protocol
Domain Name System
IP DNS Resolver
DHCP relay server
Hypertext Transfer Protocol
Internet Group Management Protocol
IPv4/IPv6 multicast configuration
Domain Name System
Add IP route
Enable routing for IPv4 and IPv6
source command
Secure Shell
verify command
22