Ip Configuration - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
Buttons
4.3.2

IP Configuration

Configure basic settings, control IP interfaces and IP routes.
IP
The maximum number of interfaces supported is 8 and the maximum number
of routes is 32.
Figure 4-3: IP Configuration
Table 4-2: IP Configuration Parameters
IP Configuration- Basic Settings
Mode
DNS Server
Save:
Click to save changes.
Reset:
Click to undo any changes made locally and revert to previously
saved values.
Configure whether the IP stack should act as a Host or a Router.
In Host mode, IP traffic between interfaces will not be routed.
In Router mode traffic is routed between all interfaces.
This setting controls the DNS name resolution done by the switch.
There are four servers available for configuration, and the index of the
server presents the preference (less index has higher priority) in doing
DNS name resolution.
System selects the active DNS server from configuration in turn, if the
preferred server does not respond in five attempts.
The following modes are supported:
No DNS server: No DNS server will be used.
Configured IPv4: Explicitly provide the valid IPv4 unicast address of
the DNS Server in dotted decimal notation.
Make sure the configured DNS server could be reachable (e.g. via PING)
for activating DNS service
. Configured IPv6: Explicitly provide the valid IPv6 unicast (except
linklocal) address of the DNS Server.
Make sure the configured DNS server could be reachable (e.g. via
PING6) for activating DNS service.
From any DHCPv4 interfaces: The first DNS server offered from a
DHCPv4 lease to a DHCPv4-enabled interface will be used.
From this DHCPv4 interface: Specify from which DHCPv4-enabled
interface a provided DNS server should be preferred.
From any DHCPv6 interfaces: The first DNS server offered from a
DHCPv6 lease to a DHCPv6-enabled interface will be used.
26