Dhcp Serverexcluded Ip Configuration - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
VLAN Mode
Configure operation mode to enable/disable DHCP server per VLAN.
Delete VLAN Mode
Indicate the VLAN range in which DHCP server is enabled or disabled.
The first VLAN ID must be smaller than or equal to the second VLAN ID. BUT, if the VLAN
range contains only 1 VLAN ID, then you can just input it into either one of the first and
second VLAN ID or both.
On the other hand, if you want to disable existed VLAN range, then you can follow the steps.:
1. press Add VLAN Range to add a new VLAN range
2. input the VLAN range that you want to disable
3. choose Mode to be Disabled.
4. press SAVE to apply the change
Then, you will see the disabled VLAN range is removed from the DHCP Server mode
configuration page.
Indicate the operation mode per VLAN. Possible modes are:
Enabled: Enable DHCP server per VLAN
Disabled: Disable DHCP server pre VLAN.
Buttons
5.2.2

DHCP ServerExcluded IP Configuration

This section configures excluded IP addresses. DHCP server will not allocate these excluded IP
addresses to DHCP client.
Figure 5-8: DHCP Server Excluded IP Configuration
Table 5-7: DHCP Server Excluded IP Configuration Parameters
Excluded IP Address
Configure excluded IP addresses.
Delete
IP Range
Save:Click to save changes.
Reset: Click to undo any changes made locally and revert to
previously saved values.
Add VLAN Range: Click to add a new VLAN range..
Delete Excluded Ip Address opperation
Define the IP Range to be excluded. The first excluded IP must be
smaller than or equal to the second excluded IP. BUT, if the IP range
contains only 1 excluded IP, then you can just input it to either one of
the first and second excluded IP or both
374