Sync Output - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
Manual State The status of the sync source.
When the source provides a valid reference clock, this indicator will be Green.
When source is disabled or not applicable, indicator will be Grey.
Manual Indicates the sync source's current (clock) quality (QL) as received from the source (e.g.
via SSM). When there is no quality indication received from the source, a default quality
Quality
value is shown with parentheses
WTR Configure the Wait To Restore (WTR) timer or disable its operation (applicable
when in Auto-Revertive mode).
Time to Indicates the time the system waits between failures of a sync source (quality
degraded) and until it is declared as disqualified (invalid).
Disqualify
Time to
Indicates the time the system waits between detection of a valid sync source
Quality
(adequate quality) and until it is declared as qualified (valid).
Holdover
Configure the time duration for holdover that after that time period, it will move
Timeout(hr)
from holdover to free running state.
Save: Click to save changes
Buttons
Refresh: Click to refresh the page immediately
.
Monitor: Direct link to the
4.11.4
4.11.5

Sync Output

Figure 4-103: Sync Output
Table 4-100: Sync Output parameters
Sync Output
Output
Locked
Quality
Buttons
SyncCenter monitoring
Indicates the type of output (e.g. SyncE).
Indicates the clock output used to synchronize the functional block in
'Output'.
Indicates the clock quality distributed on this type of output
Save: Click to save changes
Refresh Click to refresh the page immediately
.
Monitor: Direct link to the
196
page.
SyncCenter monitoring page.