Synccenter Status - FibroLAN Falcon Gen-3 M-Class User Manual

Falcon M-Class | User Guide
Table 4-104: SyncCenter parameters
SyncCenter Configuration
Shows the current system's overall synchronization mode:
Mode
and state. When higher priority source that previously failed, is valid again,
no switchover will take place.
Auto Revertive: source is automatically selected based on priority and
state. When higher priority source that previously failed, is valid again,
switchover will take place.
Manual: source will the one configured in the manual source configuration
fields, regardless of its state.
Forced Holdover: the system will be synchronized to the last selected
source, but will go into holdover mode and ignore this source.
Forced Free-running: the system will be synchronized to the local clock,
ignoring all sync sources.
Manual Type When system sync mode is set to manual the source type is shown here
(None,SyncE, PTP, TDM, External)
Manual Port When system sync mode is set to manual the source port or instance is
shown here.
Manual State
The status of the sync source
When the source provides a valid reference clock, this indicator will be
Green. When source is disabled or not applicable, indicator will be Grey.
Manual Indicates the sync source's current (clock) quality (QL) as received from the
source (e.g. via SSM).
Quality
When there is no quality indication received from the source, a default
quality value is shown with parentheses.
Configuration :Direct link to the
Buttons
Refresh: Click to refresh the page immediately.
Auto-refresh
Automatic refresh occurs every 3 seconds.
4.12.4

SyncCenter Status

Auto Non-Revertive: source is automatically selected based on priority
Check this box to refresh the page automatically.
SyncCenter configuration
201
page