Table of Contents
Advertisement
4.8.1.2. Setting the mass flow rate range (single range)
Description
● Set the range value (full scale value) for the mass flow rate being measured.
* The analog output (4 to 20 mA) corresponds to the range setting.
● Setting range: ±99999999
* The MASS FLOW UNIT must be set beforehand.
<Note> The mass flow rate unit is the unit selected at "MASS FLOW UNIT" in "MEASURE
SETUP" mode. (See Section 4.7.4)
<Note> If an analog value is output for mass flow rate, set the mass flow rate with the
analog output source designation (see section 4.8.1.3).
For concrete keying, refer to the typical operation indicated below. Set the protection to OFF
beforehand. (See Section 4.4.1.)
Operation
Set "RANGE TYPE" to "SINGLE", and "MASS FLOW FS F1" to a mass flow rate of 170.0797 kg/h.
(example)
* Set the pipe parameters and "MASS FLOW UNIT" beforehand.
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Move the cursor by the
▼
key.
Change the mass flow rate full scale to "170.079".
(Note) If changing the position of the decimal point, align the cursor with
the digit to be changed, and change in the same way by pressing the
key.
Press the
ENT
▼
Press the
ESC
measurement mode.
Description
key twice to display "OUTPUT SETUP".
key once to display "ZERO ADJUSTMENT".
ENT
key 4 times to display "RANGE".
key once to display "RANGE TYPE".
ENT
key 4 times to display "MASS FULL SCALE 1".
key once to display the cursor.
ENT
key, and change the numeric value by the
key once to register.
ENT
――― Full scale 1 has been registered. ―――
key twice and the
ESC
key 3 times to return to the
－41－
Display
OUTPUT SETUP
ZERO ADJUSTMENT
RANGE
RANGE TYPE
KIND
FLOW RATE
MASS FLOW FS1
0. 000 kg/h
MASS FLOW FS1
00000. 000 kg/h
00000. 000 kg/h
00100. 000 kg/h
00100. 000 kg/h
00170. 000 kg/h
00170. 000 kg/h
00170. 070 kg/h
00170.
070
kg/h
00170.
079
kg/h
MASS FLOW FS1
＊＊ COMPLETE ＊＊
↓
MASS FLOW FS1
170. 079 kg/h
0.000
m/s
0.000
m3/h
CLEAR
SINGLE
Advertisement
Table of Contents
