Table of Contents
Advertisement
Description of display/setting unit
○ LCD display: Displays measurement values and setting values (16 digits × 2 rows).
"Measurement display"
The data area displays a maximum of 8 digits, including the decimal point.
If the value exceeds the number of display digits, "<" is displayed at the highest digit.
If the value exceeds the range, "OVERRANGE" or "UNDERANGE" blinks in Display 2.
The displays also blink if the analog input temperature or pressure exceeds the range, or if a cable
break occurs.
The displays also blink if the resistance temperature detector measurement range (-45 to 205°C) has
been exceeded, or if a cable break occurs. If the ultrasonic receipt signal sensitivity drops, "SNR
ALARM" blinks in Display 2.
If the temperature of the resistance temperature sensor is 100°C or below, or if 10 minutes has
elapsed since the temperature exceeded 100°C, "WARMING UP" will blink on the LCD and it will enter
an error state.
Flow direction, during test mode "T"
Display 1
Display 2
Display 1
Display 2
Display 1
Display 2
Display 1
Display 2
Display 1
Display 2
LED lamp:
Indicates the received wave is normal or not.
(Green) Received ware is normal, (red) Received ware is abnormal
Set the parameter with setting keys.
ESCAPE key
UP key
SHIFT key
ENTRY key
DOWN key : DOWN key function is conducted by pressing UP key while holding down SHIFT key.
+
Data
Data
Flow direction
Data
O
V E R
R
A N G
Data
U
N
D
E R
A
Data
S
N
R
A
L
W
A
R
M I
N
Data
: Returns to the next-higher menu level or cancels the set status.
: Selects items, numeric values, and symbols.
: Moves the cursor and selects decimal place.
: Enters a selection or registers a setting.
Note) For changing the parameter, enter the changed value, and press this key to confirm
that it is registered.
Use DOWN key for selecting items, values, and codes.
Unit
Unit
Unit
E
Unit
N G E
Unit
A R M
G
U
P
Unit
－21－
Advertisement
Table of Contents
