Volume Flow Unit Setting Method - Fuji Electric FSJ Instruction Manual

Volume flow unit Setting method

Description
● Select the unit for the instantaneous VOLUME FLOW.
● Metric system
Flow rate ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ L/s, L/min, L/h, L/d, kL/d, ML/d, m
BBL/h, BBL/d, kBBL/d, MBBL/d
<Note> First, set the unit system (metric) according to Section 4.7.1
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set a flow total unit to "L/min".
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
ESC
measurement mode.
Description
key for 3 times to display "MEASURE SETUP".
key once to display "SYSTEM UNIT".
ENT
key once to display "VOLUME FLOW UNIT".
key once to blink the cursor.
ENT
key several times to display "L/min".
key once to register.
ENT
――― "L/min" has been registered. ―――
key once and key twice to return to the
ESC
/s, m /min, m /h (factory set), m
3 3 3
－33－
/d, km /d, Mm /d, BBL/s, BBL/min,
3 3 3
Display
MEASURE SETUP
SYSTEM UNIT
METRIC
VOLUME FLOW UNIT
VOLUME FLOW UNIT
VOLUME FLOW UNIT
VOLUME FLOW UNIT
 COMPLETE 
↓
VOLUME FLOW UNIT
0.000 m/s
0.000 m3/h
m3/h
m3/h
L/min
L/min