Setting The Mass Total Preset Value - Fuji Electric FSJ Instruction Manual

4.8.2.4. Setting the MASS TOTAL preset value

Description
● Preset value: Value which appears on the total counter when the total value has been reset.
Settable range:0 to 99999999
<Note> If a reset is performed, both the forward direction mass total memory and reverse direction mass total memory are reset
simultaneously.
Set the total unit (thermal) beforehand in the MEASURE SETUP mode. (Refer to section 4.7.5.)
Set the total mode to STOP before start setting.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set the preset value to 10000kg.
(example) * Set the total unit (thermal) beforehand
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼ * Note that, it cannot be entered on the first digit (leftmost).
Press the
▼
Press the
ENT
▼
――― "M:TOTAL PRESET" has been registered. ―――
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
ESC
the measurement mode.
Description
key twice to display "OUTPUT SETUP".
key once to display "ZERO ADJUSTMENT".
ENT
key for 6 times to display "TOTAL".
key once to display "TOTAL MODE".
ENT
key for 4 times to display "M:TOTAL PRESET".
key once to display the cursor.
ENT
key for 4 times to move the cursor.
key once to display "1".
key once to register.
ENT
key for 4 times to display "TOTAL MODE".
key once to blink the cursor.
ENT
key once to select "TOTAL RESET".
key once to register.
ENT
――― "TOTAL MODE" has been registered. ―――
key twice and then press the
ESC
key for 3 times to enter
－50－
Display
OUTPUT SETUP
ZERO ADJUSTMENT
TOTAL
TOTAL MODE
STOP
M:TOTAL PRESET
0
M:TOTAL PRESET
00
0000000
M:TOTAL PRESET
0 0
000 0000
M:TOTAL PRESET
0 1
000 0000
M:TOTAL PRESET
 COMPLETE 
↓
M:TOTAL PRESET
0 00010000
TOTAL MODE
TOTAL MODE
TOTAL MODE
TOTAL RESET
TOTAL MODE
 COMPLETE 
↓
TOTAL MODE
TOTAL RESET
0.000 m/s
0.000 m3/h
CLEAR
kg
kg
kg
kg
kg
STOP
STOP