Test Mode (Simulated Flow Rate Output) - Fuji Electric FSJ Instruction Manual

Test mode (simulated flow rate output)

Description
● Checks different outputs (LCD indication, analog output, DO output) upon simulating
volume flow rate outputs.
With the output at the actuated time as an initial value, the output changes up to the
input value (simulated volume flow rate target value) in a selected TRACKING TIME,
and at the input value, the output value becomes constant.
During the test mode, "T" blinks on the left end of the 1st line of LCD.
Setting content
TEST MODE
INPUT DATA
TRACKING TIME
Settable range
TEST MODE validation : SETTING (valid), NOT USED (invalid)
INPUT DATA
TRACKING TIME
* For setting TRACKING TIME, 0sec is set to the damping (See section 4.8.5)
By performing the operation, the output of analog outputs AO1 and AO2, and output DO1 and DO2 will be changed
Be sure to resume "NOT USED" after the end of test.
If "START" or "RESET" is selected as TOTAL MODE, the total value also changes. Select "STOP" to prevent the total
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set the simulated flow rate target to 100%, and the tracking time to 100 [sec].
(example) *Set the "FLOW RATE (%)" before hand. Refer to "4.8.4"
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
ENT
▼
Enter "100" by the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
: Enables or disables the test mode.
: Simulated flow rate target (percentage of MV full
scale).
: Time required to attain the simulated flow rate target
(above input value).
: ±120%
: 0 to 999 seconds
depending on the setting.
Check beforehand whether it is permitted to change each parameter.
Otherwise, the input value output status will be held until power is turned off.
value change.
Description
key for 4 times to display "MAINTENANCE MODE".
key once to display "RAS".
ENT
key for 9 times to display "TEST MODE".
key once to blink the cursor.
ENT
key once, and select "SETTING".
key once to register "SETTING".
ENT
key once to blink the cursor on the 2nd line.
ENT
key and the
key once to register.
ENT
――― "INPUT DATA" has been registered. ―――
key once to display "TRACKING TIME".
key once to blink the cursor on the 2nd line.
ENT
key.
－86－
Display
MAINTENANCE MODE
RAS 0000H
0000000000000000
TEST MODE
NOT USED
TEST MODE
NOT USED
TEST MODE
SETTING
INPUT DATA
INPUT DATA
+000 %
INPUT DATA
+100
INPUT DATA
 COMPLETE 
↓
INPUT DATA
TRACKING TIME
TRACKING TIME
000 sec
0 %
%
100 %
0 sec