4.9.5.6. Output at the minus flow direction
Description
● Select a contact output as DO1 and/or DO2 when the flow is in reverse direction.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation
Set the DO1 output to "-: FLOW DIRECTION".
(example)
Also, set the contact to "ACTIVE ON".
Key operation
Press the
▼
ENT
Press the
▼
Press the
▼
* Use the
Press the
ENT
▼
Press the
▼
2nd line.
Press the
ENT
▼
――― "-:FLOW DIRECTION" has been registered. ―――
Press the
ENT
▼
Press the
ENT
▼
* To select normally on, press the
ESC
Press the
the measurement mode.
Description
key twice to display "OUTPUT SETUP".
ENT
key once to display "ZERO ADJUSTMENT".
key for 7 times to display "DO1 OUT".
key to select "DO2 OUT".
key once to blink the cursor.
ENT
key for 13 times to display "-:FLOW DIRECTION" on the
key once to register "-:FLOW DIRECTION".
ENT
key once to display "CONTACT ACTION".
ENT
key once to register "ACTIVE ON"(normally off).
ENT
key.
――― "ACTIVE ON" has been registered. ―――
ESC
key twice and then press the
key for 3 times to enter
-72-
Display
OUTPUT SETUP
ZERO ADJUSTMENT
DO1 OUT
NOT USED
DO1 OUT
NOT USED
DO1 OUT
-:FLOW DIRECTION
DO1 OUT
COMPLETE
↓
STATUS OUT
CONTACT ACTION
CONTACT ACTION
ACTIVE ON
CONTACT ACTION
COMPLETE
↓
STATUS OUT
CONTACT ACTION
0.000
%
0.000
m3
CLEAR