Volume total unit setting method
Description
● Select the unit of total volume.
● Metric system
Flow total unit ꞏꞏꞏꞏꞏ mL, L, m
<Note> First, set the unit system (metric) according to Section 4.7.1
Set the total mode to "STOP" before setting this parameter. (See Section 4.8.2.)
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation
Set a vol. total unit to "L"
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
ESC
measurement mode.
(factory set), km
, Mm
3
3
3
Description
key for 3 times to display "MEASURE SETUP".
key once to display "SYSTEM UNIT".
ENT
key twice to display "Vol.TOTAL UNIT".
key once to blink the cursor.
ENT
key twice to display "L".
key once to register.
ENT
――― "L" has been registered. ―――
key once and
key twice to return to the
ESC
, mBBL, BBL, kBBL
-34-
Display
MEASURE SETUP
SYSTEM UNIT
METRIC
Vol.TOTAL UNIT
Vol.TOTAL UNIT
Vol.TOTAL UNIT
Vol.TOTAL UNIT
COMPLETE
↓
Vol.TOTAL UNIT
0.000
L
0.000
L/min
m3
m3
L
L