How To Set The Maintenance Period - Fuji Electric FSJ Instruction Manual

4.9.5.8. How to set the maintenance period

Description
● MAINTENANCE: Contact output is activated for DO1 and DO2 when the maintenance period has elapsed.
The maintenance period is two years.
Two years after the maintenance period setting (Section 4.11.14) was set to START, contact output is activated for
DO1 and DO2.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set the DO1 output to "MAINTENANCE".
(example) Also, set the contact to "ACTIVE ON".
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
* Use the
ENT Press the
▼
Press the
▼
row.
ENT Press the
▼
ENT Press the
▼
ENT Press the
▼
* To select normally on, press the
ESC Press the
enter the measurement mode.
Description
key twice to display "OUTPUT SETUP".
key once to display "ZERO ADJUSTMENT".
ENT
key for 7 times to display "DO1 OUT".
key to select "DO2 OUT".
key once to blink the cursor.
ENT
key 15 times to display "MAINTENANCE" on the second
key once to register "INPUT ALARM".
ENT
――― "MAINTENANCE" has been registered. ―――
key once to display "CONTACT ACTION".
ENT
key once to register "ACTIVE ON"(normally off).
ENT
――― "ACTIVE ON" has been registered. ―――
key twice and then press the
ESC
key.
key for 3 times to
－74－
Display
OUTPUT SETUP
ZERO ADJUSTMENT
DO1 OUT
NOT USED
DO1 OUT
NOT USED
DO1 OUT
MAINTENANC
MAINTENANC
 COMPLETE 
↓
STATUS OUT
CONTACT ACTION
CONTACT ACTION
ACTIVE ON
CONTACT ACTION
 COMPLETE 
↓
STATUS OUT
CONTACT ACTION
0.000 m/s
0.000 m3
CLEAR