Setting The Id No; Confirming The Software Version - Fuji Electric FSJ Instruction Manual

Setting the ID No.

Description
● Set the ID No. for parameters (Section 4.4.1).
If ID No. is set, the number must be inputted before canceling the protection.
To set the protection, set the protection to "ON". (See Section 4.4.1.)
● ID No. settable range: 0000 to 9999 (4-digit number)
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
If you forget the ID number you set, contact us.
Operation Set "1106" as the ID No.
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Set "1106" by the
▼
Press the
ENT
▼
ESC Press the
measurement mode.
Note) To set the protection, set the protection to "PROTECT ON". (See
Section 4.4.1.)

Confirming the software version

Description
● Indicates the software version.
For actual keying, refer to the typical operation indicated below.
Operation Check the software version.
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
After checking, display the measurement mode by the
ESC
key.
Description
key for 4 times to display "MAINTENANCE MODE".
key once to display "RAS".
ENT
key for 12 times to display "REGISTER ID NO.".
key twice to blink on the 2nd line.
ENT
key and the
key once to register.
ENT
――― ID NO. has been registered. ―――
ESC key twice and then press the
Description
key for 4 times to display "MAINTENANCE MODE".
key once to display "RAS".
ENT
key for 13 times to display "VER. NO.".
key.
key once to enter the
key or the
ESC
* The indicated version number is display example.
－90－
Display
MAINTENANCE MODE
RAS 0000H
0000000000000000
REGISTER ID NO.
REGISTER ID NO.
REGISTER ID NO.
REGISTER ID NO.
 COMPLETE 
↓
REGISTER ID NO.
0.000 %
0.000 m3
Display
MAINTENANCE MODE
RAS 0000H
0000000000000000
FSJ****1
Ver.02A 23
0.000 %
0.000 m3/h
0000
1106
