Pressure unit setting method
Description
● Select the pressure unit for the analog input AI read from pressure gauge output.
● Metric system
Pressure unit ꞏꞏꞏꞏꞏ MPa (G) (factory default), bar (G) (G: gauge pressure)
<Note> First, set the unit system (metric system) based on section 4.7.1.
For concrete keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation
Set the pressure unit to "MPa (G)".
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
"MPa (G)" (factory default) is already registered.
If setting another unit, change using the
ESC
Press the
measurement mode.
Description
key 3 times to display "MEASURE SETUP".
key once to display "SYSTEM UNIT".
ENT
key 5 times to display "PRESSURE UNIT".
ESC
key once and the
key and
key.
ENT
key twice to return to the
-37-
Display
MEASURE SETUP
SYSTEM UNIT
METRIC
PRESSURE UNIT
0.000
L
0.000
L/min
MPa (G)