Range Over Output And Pulse Range Over; Output - Fuji Electric FSJ Instruction Manual

4.9.5.5. Range over output and pulse range over output
Description
● AO RANGE OVER
● PULSE RANGE OVER :
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set the DO1 output to "AO RANGE OVER".
(example) Also, set the contact to "ACTIVE ON".
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
* Use the
ENT Press the
▼
Press the
▼
2nd line.
* Press the
Press the
ENT
▼
ENT Press the
▼
Press the
ENT
▼
* To select normally on, press the
Press the
ESC
the measurement mode.
: Contact output to DO1 and/or DO2 are activated when the flow rate is outside the setting range.
Contact output to DO1 and/or DO2 are activated when the total pulse output exceeds the maximum
output frequency value.
Description
key twice to display "OUTPUT SETUP".
key once to display "ZERO ADJUSTMENT".
ENT
key for 7 times to display "DO1 OUT".
key to select "DO2 OUT".
key once to blink the cursor.
ENT
key for 11 times to display "AO RANGE OVER" on the
key again to display "PULSE RANGE OVER".
key once to register "RANGE OVER".
ENT
――― "RANGE OVER" has been registered. ―――
key once to display "CONTACT ACTION".
ENT
key once to register "ACTIVE ON"(normally off).
ENT
――― "ACTIVE ON" has been registered. ―――
key twice and then press the
ESC
key.
key for 3 times to enter
－71－
Display
OUTPUT SETUP
ZERO ADJUSTMENT
DO1 OUT
NOT USED
DO1 OUT
NOT USED
DO1 OUT
AO RANGE OVER
DO1 OUT
 COMPLETE 
↓
STATUS OUT
CONTACT ACTION
CONTACT ACTION
ACTIVE ON
CONTACT ACTION
 COMPLETE 
↓
STATUS OUT
CONTACT ACTION
0.000 %
0.000 m3
CLEAR