Copy Function Related Displays; Copy Function Related Displays; Tasks, Errors, And Troubleshooting - YASKAWA iQpump1000 Quick Start Manual

5.6

Copy Function Related Displays

u

Tasks, Errors, and Troubleshooting

The table below lists the messages and errors that may appear when using the Copy function.
When executing the tasks offered by the Copy function, the keypad will indicate the task being performed. When an error
occurs, a code appears on the keypad to indicate the error. Note that errors related to the Copy function do not trigger a multi-
function output terminal that has been set up to close when a fault or alarm occurs. To clear an error, simply press any key on
the keypad and the error display will disappear.
Table 5.6 lists the corrective action that can be taken when an error occurs.
Note: 1. Whenever using the copy function, the drive should be fully stopped.
2. The drive will not accept a Run command while the Copy function is being executed.
3. Parameters can only be saved to a drive when the voltage class, capacity, control mode, and software version match.
HOA Keypad Display
CoPy
Cause
Parameters are being written to the drive.
HOA Keypad Display
CPyE
Cause
Failed writing parameters
HOA Keypad Display
CSEr
Cause
Hardware fault
HOA Keypad Display
dFPS
Cause
The drives used in the copy and write process are
not the same model.
• The drive from which the parameters were
copied is a different model.
• The drive to be written to is a different model.
HOA Keypad Display
End
Cause
Finished reading, writing, or verifying parameters. This is not an error.
HOA Keypad Display
iFEr
Cause
A communication error occurred between the drive
and the HOA keypad or the USB copy unit.
A non-compatible cable is being used to connect
the USB Copy Unit and the drive.
HOA Keypad Display
ndAT
Cause
YASKAWA TOEP YAIP1W 01A YASKAWA AC Drive - iQpump1000 Quick Start Guide
Table 5.6 Copy Function Task and Error Displays
Writing Parameter Settings (flashing)
This is not an error.
Error Writing Data
Attempt to write parameters again.
Copy Unit Error
Replace the HOA keypad or the USB Copy Unit.
Drive Model Mismatch
• Verify the model number of the drive from which the parameters were copied and the model of
the drive to which those parameters will be written.
• Make sure the two drives are the same model and have the same software version.
Task Complete
Communication Error
Check the cable connection.
Use the cable originally packaged with the USB Copy Unit.
Model, Voltage Class, Capacity Mismatch

5.6 Copy Function Related Displays

Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
5
211