YASKAWA iQpump1000 Quick Start Manual page 6

Step
Changing Parameters and
5
Monitoring the iQpump
This step shows how to access and modify an iQpump parameter
as well as how to monitor iQpump signals such as output
frequency and motor current.
Make sure all protective covers have been re-attached and power
is turned on. DO NOT RUN THE MOTOR.
Access Parameter Menu and Change Parameter Value
Press two times until the digital operator shows the parameter menu.
2X
Inc./Dec. Selection
Switch to Edit Mode
Hold button for 3 sec. to go back to the main menu.
Monitor Motor Frequency and Motor Current
iQpump Digital Operator power-up state
Output Frequency and Transducer Feedback can be monitored
simultaneously. Use
Press simultaneously shows the monitor menu.
Press
Use
Please refer to the iQpump Quick Start Manual, (Document No.
TOEP YAIP 1W 01) on how to access other drive monitors.
6
Select Digit
2X
Go to Next Digit Inc./Dec. Selection
Modify Value Save New Value
and to select monitor signals.
to access monitor menu.
to select monitor.
Step
6
This step shows how to configure the iQpump for a dedicated pump
application.
Make sure all protective covers have been re-attached and power is
turned on. DO NOT RUN THE MOTOR.
Available iQpump Application Macro's:
6008 Constant Pressure Mode (PSI )
6009 Pump Down Level Mode (Ft)
6010 Geothermal Mode
6011 VTC Pressure Control Mode
7770 General Purpose Mode
Select Application
Press two times until the digital operator shows the parameter menu.
2X
Inc./Dec. Selection
Enter Application Parameters
Hold button for 3 sec. to go back to the main menu.
3X
Switch to Edit Mode
Go Back to Main Menu
Hold button for 3 sec. to go back to the main menu.
YASKAWA TOEP YAIP1W 01A YASKAWA AC Drive - iQpump1000 Quick Start Guide
Application Setup
Default
The factory default is setup for
constant pressure PSI, only
change if application different.
2X
Select Digit
Switch to Edit Mode Select Application
Press to select.
Select Parameter.
Modify Value Save New Value