YASKAWA iQpump1000 Quick Start Manual page 150

4.6 Basic iQpump Setup and Application Preset Parameters
2-Wire Control
Notes on Parameter Initialization
The parameters shown in
No.
A1-00
E1-03
F6-08
L8-35
o2-04
Setting 5550: Terminal/Control Initialize
An oPE04 error appears on the digital operator when a terminal block with settings saved to its built-in memory is installed
in a drive that has edited parameters. Set A1-03 to 5550 to use the parameter settings saved to the terminal block memory.
Application Presets are available to facilitate drive setup for commonly used applications. Selecting one of these Application
Presets automatically assigns functions to the input and output terminals and sets a predefined group of parameters to values
appropriate for the selected application.
In addition, the parameters most likely to be changed are assigned to the group of User Parameters, A2-01 through A2-16.
User Parameters are part of the Setup Group, which provides quicker access by eliminating the need to scroll through multiple
menus.
Refer to Pump Application Presets on page 118
Setting 6008: Pressure Control
Application Preset for Pressure Control applications.
and default values for this Application Preset.
Setting 6009: Pump Down Level
Application Preset for Pump Down Level applications.
and default values for this Application Preset.
Setting 6010: Geothermal Mode
Application Preset for Geothermal Mode.
values for this Application Preset.
Setting 6011: VTC Pressure Mode
Application Preset for VTC Pressure Mode.
default values for this Application Preset.
Setting 7770: General Purpose
General Purpose Application Preset.
for this Application Preset.
150
S1
FWD Run/Stop
SN
Figure 4.24 2 & 3-Wire Control Wiring Examples
Table 4.16 will not be reset when the drive is initialized by setting A1-03 = 2220 or 3330.
Table 4.16 Parameters Not Changed by Drive Initialization
for detailed information on Application Presets.
Refer to Pump Application Presets on page 118
Refer to Pump Application Presets on page 118
Refer to Pump Application Presets on page 118
Operation switch
Stop switch
(NO contact)
(NC contact)
3-Wire Control
Parameter Name
Language Selection
V/f Pattern Selection
Communication Parameter Reset
Installation Selection
Drive/kVA Selection
Refer to Pump Application Presets on page 118
Refer to Pump Application Presets on page 118
YASKAWA TOEP YAIP1W 01A YASKAWA AC Drive - iQpump1000 Quick Start Guide
S1
Run command
(Run on momentary close)
S2
Stop command
(Stop on momentary open)
SN
Sequence input common
for a list of parameters
for a list of parameters
for a list of parameters and default
for a list of parameters and
for a list of parameters and default values