Assigning A Static Ipv4 Address To The Access Point; Figure 10: Network Static Ip Address Window - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

Assigning a Static IPv4 Address to the Access Point

This section explains how to manually assign an IP address to the access
point. The unit uses the address to communicate with devices on your
network, such as management workstations, syslog servers, and RADIUS
servers. The access point can have only one IP address.
If you prefer the access point obtain its IP configuration from a DHCP
server on your network, refer to "Assigning a Dynamic IP Address from a
DHCP Server" on page 44.
Note
Changing the IP address of the access point might interrupt your
management session. To resume managing the device, start a new
session using the access point's new IP address.
To assign a static IP address to the device, perform the following
procedure:
1. Select Settings > System from the main menu.
2. Select Network from the sub-menu.
3. Select Static IP from the Connection Type pull-down menu. The
options in the window change. Refer to Figure 10.
Figure 10. Network Static IP Address Window
Chapter 3: System Settings
47