Table of Contents
Advertisement
TQ6000 GEN2 Access Points User's Guide
Configuring VAP Security
No Security
110
The procedures for configuring VAP security is provided in the following
sections:
"No Security" on page 110
"Static WEP" on page 111
"WPA Personal (Pre-Shared Key)" on page 113
"WPA Enterprise" on page 116
Note
OSEN is not supported.
VAPs not requiring any security can be set to the None security level.
Wireless clients do not use encryption or authentication to access VAPs
with no security. This is the default setting.
To configure a VAP for no security, perform the following procedure:
1. Select Settings > VAP / Security from the main menu.
2. Select Radio1 or Radio2 from the sub-menu. The default is Radio1.
You can configure only one radio at a time.
3. Select a VAP to configure from the next sub-menu. The default is
VAP0.
Note
You can configure multiple VAPs without saving each VAP
configuration page. You can save multiple VAP configurations all at
once by clicking the SAVE & APPLY button.
4. Select the Security tab.
5. Select None from the Mode pull-down menu. This is the default
setting. See Figure 36 on page 111.
Advertisement
Table of Contents
