Table 29. Vap Advanced - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

Field
Inactivity Timer Not supported. The value is always 300 seconds.
Duplicate AUTH Controls how the access point responds when it
Received receives authentication requests from wireless clients
that has been already authenticated.
The options are listed here:
- Disconnect: The access point responds to duplicate
authentication requests by sending
deauthentications and disconnecting the clients. This
is the default setting.
- Ignore: The access point responds to duplicate
authentication requests by authenticating the clients
again.
Association Controls whether the access point informs other access
Advertisement points of newly associated clients, over the wired
network. When the access point associates new
clients, it can inform the access points to which the
clients were previously connected of the change. This
enables access points to update their lists of
associated clients more quickly. The options are listed
here:
- Disabled: The access point does not inform other
access points of newly associated clients. This is the
default setting.
- Enabled: The access point does inform other access
points of new clients.
Other access points on the same subnet must have
Association Advertisement enabled to function this
feature.

Table 29. VAP Advanced

Description
Note
To use this feature, the IEEE802.11w (MFP) field
must be set to "Disabled." See "WPA Personal
(Pre-Shared Key)" on page 113.
Chapter 7: Virtual Access Points
151