Allied Telesis AT-TQ6702 GEN2 Quick Installation Manual

Quick Installation Guide
TQ6702 GEN2 Wireless Access Points
The access point models included in this Quick Installation guide are:
AT-TQ6702 GEN2

AT-TQ6702 GEN2-R

AT-TQm6702 GEN2

Note
The AT-TQ6702 GEN2-R wireless router shares the same chassis design with the
AT-TQ6702 GEN2 and AT-TQm6702 GEN2 access points so that they look the
same. To distinguish one model from the others, place a sticker with a model
name on the plastic part of the device as necessary.
Installation and User's Guides
This document contains an abbreviated version of the installation instructions for the
TQ6702 GEN2 Wireless Access Points. For complete installation instructions, see the
TQ6702 GEN2 Wireless Access Points Installation Guide.
For management instructions, see TQ6000 GEN2 Management Software User's Guide for
the TQ6702 GEN2 and TQm6702 GEN2 models, and Getting Started with the Device GUI
on the TQ6702 GEN2-R Wireless Router for the TQ6702 GEN2-R model. The documents
are on the Allied Telesis web site at www.alliedtelesis.com/library.
Physical Description
Console Port
DC IN Connector
for AC/DC Adapter
LAN1 POE+ Port
Power Switch
LAN2 POE+ Port
Reset Button
The Console ports on the TQ6702 GEN2 and TQm6702 GEN2 models are for
manufacturing purposes only. For the TQ6702 GEN2-R device, you can access the
AlliedWare Plus™ operating system through the Console port and configure the device.
Safety Precautions and Site Requirements
Review the safety precautions and site requirements in the TQ6702 GEN2 Wireless
Access Points Installation Guide before installing the device.
*613-003195 Rev C*
613-003195 Rev C
Package Contents
The wireless access points come with the following items in the shipping container:
One TQ6702 GEN2 Wireless Access Point

This Quick Installation Guide

One mounting bracket

Two M5 x4.5 mm pan-head screws for the mounting bracket

If any item is missing or damaged, contact your Allied Telesis sales representative for
assistance. You should retain the original shipping material in case you need to return the
unit to Allied Telesis.
Installation Options
You can install the access point on a desktop, celling, or wall. See the correct access point
orientations:
Desktop
Ceiling
Wall
Do not install the access point facing down.
1
Pre-fitting the Mounting Bracket
Before installing the mounting bracket on a wall or ceiling, pre-fit the bracket to the
access point.
1. Place the access point upside down on a table.
2. Install the two screws (provided) fully into the bottom panel of the access point.
The screw collar provides the proper spacing for the mounting bracket beneath the
screw head.
3. Make sure that the mounting bracket fits to the access point by sliding the bracket
beneath the screws.
4. Slide the mounting bracket forward and remove it from the access point.
2
Collar
3