Introduction To Quality Of Service - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

TQ6000 GEN2 Access Points User's Guide

Introduction to Quality of Service

158
Each radio in the access point has four QoS egress queues and four
ingress queues. There are parameters that control the manner in which
the device stores and handles packets in the queues. You should not
adjust these values unless you are familiar with QoS. The parameters are
divided into the following two groups:
Access Point (AP) Enhanced Distributed Channel Access (EDCA)

Parameters table contains parameters that control the four queues
that store egress traffic the access point transmits to the wireless
clients.
The Station Enhanced Distributed Channel Access (EDCA)

Parameters table controls the four queues that store ingress traffic
the access point receives from the clients.
To configure the QoS settings for the radios, perform the following
procedure.
1. Select Settings > QoS from the main menu.
2. Select Radio1 or Radio2 from the sub-menu. You can configure only
one radio at a time. Refer to Figure 55 on page 159.
3. Configure the QoS parameters by referring to the following sections:
"Configuring QoS Basic Settings" on page 160

"Configuring AP EDCA Parameters" on page 161

"Configuring Station EDCA Parameters" on page 164

4. Click the SAVE & APPLY button to save and update your
configuration.