Setting The Country Code Setting - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

Setting the Country Code Setting

Note
You cannot change the country code on units sold in North America,
Japan, Canada, or Taiwan.
You should set the country code setting of the access point as soon as you
install the unit so that it operates in compliance with the codes and
regulations of your region or country.
Note
Changing the country setting disables the radios. The procedure is
disruptive to the operations of your network if the unit is actively
forwarding network traffic.
To set the country code setting, perform the following procedure:
1. Select Settings > Radio.
2. Select Radio1 from the sub-menu. The country code must be set from
Radio1.
3. Click the Basic Settings tab. This is the default tab. Refer to Figure 27
on page 78.
4. Select the Country Code pull-down menu and choose your country or
region. Here are the guidelines:
You can select only one country.

The Country Code parameter is shown in the Basic Settings

windows of both radios, but can only be set from Radio1.
The same country code applies to Radio2.

Changing the country code disables the radios.

You have to reconfigure the radio settings after changing this

parameter.
5. Click the SAVE & APPLY button to save and update the configuration.
Chapter 5: 2.4GHz and 5GHz Radios
91