Restoring The Default Settings To The Access Point - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

TQ6000 GEN2 Access Points User's Guide

Restoring the Default Settings to the Access Point

170
This procedure explains how to restore the default settings on the access
point. Review the following information before performing the procedure:
The manager name and password are reset to "manager" and

"friend", respectively.
If the access point currently has a static IP address, the address is

deleted and the DHCP client is activated. If the device does not
receive a response from a DHCP server on the LAN port, it uses
the default IP address 192.168.1.230.
Note
The default setting for the radios is off. Consequently, the access
point stops forwarding network traffic when returned to its default
settings.
To activate the default settings on the access point, perform the following
procedure:
1. Select Maintenance > Configuration from the main menu. Refer to
Figure 56 on page 168.
2. Click the Initialize button in the Factory Default section of the window.
3. At the confirmation prompt, click OK to restore the default settings or
Cancel to cancel the procedure.
4. After clicking OK, wait one minute for the device to reset, and
afterwards establish a new management session. For instructions,
refer to "Starting the First Management Session" on page 23.