Allied Telesis TQ6702e GEN2 Quick Installation Manual

Quick Installation Guide
TQ6702e GEN2 Wireless Access Point
The access point model included in this Quick Installation guide is:
AT-TQ6702e GEN2

Installation and User's Guides
This document contains an abbreviated version of the installation instructions for the
TQ6702e GEN2 Wireless Access Point. For complete installation and management
instructions, see the TQ6702e GEN2 Wireless Access Point Installation Guide and
TQ6702e GEN2 Management Software User's Guide on the Allied Telesis web site at
www.alliedtelesis.com/library.
Safety Precautions and Site Requirements
Review the safety precautions and site requirements in the TQ6702e GEN2 Wireless
Access Point Installation Guide before installing the device.
Safety and Electromagnetic Emissions Certificates
This device complies with Part 15 of FCC Rules, Directive 2014/53/EU issued by the
Commission of the European Community, some other safety, electromagnetic emission,
and radio certificates.
Physical Description
Front Panel
5GHz Antenna
2.5G/ 5GHz Dual-band
Connectors
Antenna Connector
Ethernet LAN
and PoE++ Port
Back Panel
5GHz Antenna Connectors
®
Gore Vent
2.5 / 5GHz Dual-band Antenna Connectors
*613-003135 Rev C*
613-003135 Rev C
TQ6702e Access Point Package Contents
Four 5GHz single band
antennas
Four 2.4G/5GHz dual band
antennas
One mounting base
Four sets of a screw (M6xP1.0
16mm), washer, and spring
washer for the mounting base
One pole-mount bracket
Four sets of a Hex-head bolt,
washer, and spring washer for
pole-mount bracket
Two U-bolts
2.5G/ 5GHz Dual-band
Antenna Connector
Four nuts for the U-bolts
Two pole straps
LEDs and
Reset Button
One 8AWG ground cable
One screw with a washer and
spring washer for the ground
cable
Eight external surge protectors
with nuts, metal washer, and
rubber washers
If any item is missing or damaged, contact your Allied Telesis sales representative for
assistance. Retain the original shipping material to return the unit to Allied Telesis.
1
Attaching the Ground Cable to the Access Point
1. Select a ground post on the access point for the ground wire.
The access point has two ground posts on the bottom panel. Use either post.
2. Insert the screw through the ground lug on the ground wire and secure the wire to
the selected ground post on the access point, using a Phillips-head screwdriver.
Ground Post
Note
The ground wire must be 20AWG or larger; the screw must be 3.5mm or larger.
3. Attach the other end of the ground wire to a circuit breaker, ground rod, or earth
ground.
Note
Keep the ground cable as short as possible; remove any extra cable.
Connecting an Ethernet Cable to the Access Point
1. Place the access point on a table or desk.
2. Unscrew the cap on the LAN port and remove it from the access point.
3. Disassemble the sealing nut, clamping claw, and sealing insert.
4. Slide the Ethernet LAN cable through the sealing nut and clamping claw.
Sealing
Ground
Nut
Lug
5. Open the sealing insert and slip it onto the Ethernet wire.
The end with the groove needs to be towards the clamping claw. The fingers on the
clamping claw need to be pointing towards the sealing nut.
2
Ground Post
Clamping Claw
3