6. Click the SAVE & APPLY button to save and update the configuration,
Static WEP
To configure a VAP for Static WEP security, perform the following
procedure:
1. Select Settings > VAP / Security from the main menu.
2. Select Radio1 or Radio2 from the sub-menu. The default is Radio1.
3. Select a VAP to configure from the next sub-menu. The default is
4. Select the Security tab.
5. Select Static WEP from the Mode pull-down menu. See Figure 37 on
Figure 36. None Selection in the VAP Security Tab
or configure other VAPs and save the configurations at once later.
Note
Static WEP is only supported when the radio mode is set to
IEEE802.11b/g or IEEE802.11/a. See "Configuring Basic Radio
Settings" on page 78.
You can configure only one radio at a time.
VAP0.
Note
You can configure multiple VAPs without saving each VAP
configuration page. You can save multiple VAP configurations all at
once by clicking the SAVE & APPLY button.
page 112.
Chapter 7: Virtual Access Points
111