Configuring Basic Vap Parameters; Figure 34: Virtual Access Point Tab - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

Configuring Basic VAP Parameters

To configure basic VAP settings, perform the following procedure:
1. Select Settings > VAP / Security from the main menu.
2. Select Radio1 or Radio2 from the sub-menu. The default is Radio1.
You can configure only one radio at a time.
3. Select a VAP to configure from the next sub-menu. The default is
VAP0.
Note
You can configure multiple VAPs without saving each VAP
configuration page. You can save multiple VAP configurations all at
once by clicking the SAVE & APPLY button.
4. Select the Virtual Access Point tab. This is the default tab. The
example in Figure 34 shows the settings for VAP0 on Radio1.
Figure 34. Virtual Access Point Tab
5. Configure the parameters by referring to Table 19 on page 106.
Chapter 7: Virtual Access Points
105