Authenticating Using Mac Address List; Figure 43: Mac Access Control - Mac Address List Window - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

Authenticating
Using MAC
Address List
This section contains the procedure for authenticating wireless clients on
VAPs with the access point's on-board MAC address list. The list consists
of the MAC addresses of wireless clients that the access point is to accept
or reject on the VAPs. To configure the MAC address list, see
""Configuring MAC Access Control Settings" on page 153.
To configure MAC Access Control with external RADIUS server, perform
the following procedure:
1. Select Settings > VAP / Security from the main menu.
2. Select Radio1 or Radio2 from the sub-menu. The default is Radio1.
You can configure only one radio at a time.
3. Select a VAP to configure from the next sub-menu. The default is
VAP0.
Note
You can configure multiple VAPs without saving each VAP
configuration page. You can save multiple VAP configurations all at
once by clicking the SAVE & APPLY button.
4. Select the MAC Access Control tab. See Figure 40 on page 121.
5. Select MAC Address List from the MAC Access Control pull-down
menu. See Figure 43.
Figure 43. MAC Access Control - MAC Address List Window
Note
You must prepare a MAC address list. See "Configuring MAC
Access Control Settings" on page 153.
Chapter 7: Virtual Access Points
127