Manually Setting The Date And Time; Figure 13: Time Window - Manually Option - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

Manually Setting the Date and Time

This section explains how to manually set the date and time on the access
point.
Note
The access point does not have a real-time clock with backed up
batteries. Consequently, the date and time, when set manually, are
returned to their default values (Jan 1 00: 00: 00 2018) when the
device is reset or powered off.
Note
Allied Telesis recommends using an SNTP server to set the date
and time. For instructions, refer to "Setting the Date and Time with
the Network Time Protocol (NTP)" on page 50.
To manually set the date and time, perform the following procedure:
1. Select Settings > System from the main menu.
2. Select Time from the sub-menu. Refer to Figure 13.
Figure 13. Time Window - Manually Option
Chapter 3: System Settings
53