Table of Contents
Advertisement
TQ6000 GEN2 Access Points User's Guide
172
The version number of the current firmware is displayed in the
Firmware Information section of the window.
2. Click the Browse button next to the New Firmware Image field and
locate the new image file on your computer or network server.
3. Click the Upgrade button.
The access point displays a confirmation prompt.
4. Click the Proceed button to start the upgrade procedure or Cancel to
cancel the procedure.
5. Wait ten minutes for the access point to upload the firmware, write it
into its flash memory, and reboot.
Note
Do not close the web browser window or change to a different
window until the entire procedure is finished. Interrupting the
transfer may corrupt the file on the access point.
6. To continue managing the device, start a new management session.
Figure 57. Upgrade Window
Advertisement
Table of Contents
