Configuring Snmpv1, Snmpv2, And Snmpv3; Figure 15: Snmp Window - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

Configuring SNMPv1, SNMPv2, and SNMPv3

You can use SNMP to view the settings and client statistics on the access
point, and receive traps. Here are the guidelines:
You cannot use SNMP to change the settings on the access point.

The access point has one read-only community string.

The unit must have an IP address for SNMP management.

For more information, see"Assigning a Dynamic IP Address from a
DHCP Server" on page 44 or "Assigning a Static IPv4 Address to
the Access Point" on page 47.
To enable or disable SNMP, perform the following procedure:
1. Select Settings > System from the main menu.
2. Select SNMP from the sub-menu. Refer to Figure 15.
3. Select Disabled or Enabled in the Status field. To configure SNMP,
select Enabled.
When Enabled is selected, the SNMPv1 and SNMPv2 or SNMPv3
configuration window appears. See Figure 16 on page 58.
Figure 15. SNMP Window
Chapter 3: System Settings
57