3. Select a VAP to configure from the next sub-menu. The default is
VAP0.
Note
You can configure multiple VAPs without saving each VAP
configuration page. You can save multiple VAP configurations all at
once by clicking the SAVE & APPLY button.
4. Select the Captive Portal tab.
5. Select External RADIUS from the Captive Portal pull-down menu. See
Figure 48.
6. Select Disabled from the Authentication Page Proxy pull-down menu.
Figure 49. Capital Portal - RADIUS and Authentication Page Proxy
7. Configure the parameters described in Table 27 on page 142.
Chapter 7: Virtual Access Points
141