Chapter 2: Installing The Wireless Access Point - Allied Telesis AT-TQ6602 GEN2 Installation Manual

Chapter 2
Installing the Wireless Access Point
This chapter contains the installation procedures for the TQ6602 GEN2
Access Points. The procedures are detailed in the following sections:
"Reviewing Safety Precautions" on page 32

"Unpacking the Shipping Box" on page 35

"Reviewing Installation Guidelines" on page 36

"Installing the Access Point on a Table" on page 38

"Overview to Installing the Access Point on a Wall or Ceiling" on

page 39
"Pre-fitting the Mounting Bracket on the Access Point" on page 40

"Installing the Mounting Bracket on a Wall or Ceiling" on page 42

"Connecting Ethernet Cables to LAN1 and LAN2 Ports" on page 46

"Connecting the AC Power Adapter" on page 48

"Attaching the Access Point to the Mounting Bracket" on page 49

"Installing an Anti-theft Device" on page 52

"Starting the First Management Session" on page 53

Note
The non-US models of this product have a country code setting that
must be set during the initial management session of the units. The
setting ensures that the units operate in compliance with the laws
and regulations of your country or region.
For the US model, the country code is preset and cannot be
changed. Per FCC regulations, the country code setting for all WiFi
products marketed in the US must be fixed to US operational
channels only.
31