Configuring Qos Basic Settings; Table 30. Qos Window - Basic Settings - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

TQ6000 GEN2 Access Points User's Guide

Configuring QoS Basic Settings

160
The fields for the Basic Settings section are defined in Table 30.

Table 30. QoS Window - Basic Settings

Parameter
WiFi Multimedia
(WMM)
No
Acknowledgment
APSD
Description
Enable or disable QoS prioritizing and
coordination. Here are the options:
- Enabled: The access point uses the AP EDCA
settings to control the flow of downstream
traffic to the wireless clients and the station
EDCA parameters to control the flow of
upstream traffic from the clients. This is the
default setting.
- Disabled: QoS control of the upstream traffic
from the clients is disabled. You can still
configure some of the parameters that control
the downstream traffic from the access point to
the clients.
WMM must be enabled on radios that use IEEE
802.11n or IEEE 802.11ac.
Enable or disable No Acknowledgment.
Acknowledgment is a verification signal data that
wireless clients transmit to the access points. The
Acknowledgment process takes bandwidth and
airtime. Here are the options:
- Enabled: The access point removes
Acknowledgment to improve the amount of
data transmission.
- Disabled: No Acknowledgment is disabled.
This is the default setting.
Enable or disable Automatic Power Save Delivery
(APSD). APSD allows wireless clients to enter
standby or sleep mode to in order to save battery
while connected to the access point. Here are the
options:
- Enabled: Enable APSD.
- Disabled: Disable APSD.