Starting A Management Session; Figure 1: Log On Window - Allied Telesis TQ6000 GEN2 Series Management Software User Manual

TQ6000 GEN2 Access Points User's Guide

Starting a Management Session

26
This section explains how to start a management session on the access
point from your management workstation, using a web browser. The
procedure assumes that the access point has already been assigned an
IP address, either manually or from a DHCP server.
Note
If the access point is using its default address 192.168.1.230, see
"Starting the First Management Session" on page 23 for instructions.
To start a management session on the access point, perform the following
procedure:
1. Open the web browser on your management workstation.
2. Enter the IP address of the access point in the URL field of the web
browser.
Note
Precede the IP address with HTTPS:// if the access point is already
configured for HTTPS management. The default is HTTP
management.
See the log on window shown in Figure 1 as an example.
Figure 1. Log On Window