Installing A Fluid Line - Waters Xevo TQ-S Operator's, Overview And Maintenance Manual

6. Grasping the PEEK fluid connector, draw the fluid line out and away
from the connector plate.
7. Dispose of all parts of the fluid line assembly in accordance with
standard laboratory procedures for contaminated vessels and sharps.

Installing a fluid line

Required materials
• Chemical-resistant, powder-free gloves
• Fluid line assembly
Warning:
toxic materials, and to avoid spreading contamination to
uncontaminated surfaces, wear clean, chemical-resistant,
powder-free gloves while performing this procedure. The source
components can be contaminated.
Warning:
performed on its source before beginning this procedure.
To install a fluid line:
1. Prepare the instrument for working on its source (see
Warning:
with the probe and source; these components can be hot.
2. Open the source enclosure door, and then locate the fluid line connector
plate.
3. Identify the correct hole in the connector plate, and thread the loose
(unfitted) end of the fluid line through the aperture until the O-ring and
compression fitting protrude from the left-hand side of the fluid
connector plate (see
4. Press the O-ring until it snaps into place around the base of the
compression fitting.
5. Route the loose (unfitted) end of the fluid line through the fluid line
aperture and out of the source enclosure.
To avoid personal contamination with biohazards or
To avoid electric shock, prepare the instrument for work
To avoid burn injuries, take great care while working
"Fluid line connections:" on page
Replacing the ionKey source fluid lines
February 28, 2014, 715002212 Rev. C
page 98).
217).
219