Set Up & Interface Errors - IMO iDrive EDX 100V series 1-ph/0.2 – 0.75kW (0.25 – 1HP) Owner's Manual

5.1.2 Set up & Interface Errors.
Display Error
SP0
Zero speed stop
SP1
Fail to start
directly
SP2
Keypad
emergency stop
E.S.
External
emergency stop
External base
b.b.
block
PID feedback
PID
signal fault
REMOTE
KEYPAD cable
broken
Displayed when set frequency <0.1Hz
Increase frequency reference signal.
1. If the iDrive is set to external control mode (A00 = 001), and
direct start is disabled (b33=001), the iDrive cannot be
started and will flash STP1 when Run command in ON when
power is applied (see descriptions of b33).
2. Direct start is possible when b33 = 000.
1. If the iDrive is set to external control mode (A00=001) the
iDrive will stop according to the setting of b92 when stop key
is pressed. STP2 flashes after stop. Turn the Run switch to
OFF and then ON again to restart the iDrive.
2. If the iDrive is in communication mode and Stop key is
enabled, the iDrive will stop as set by b92 when Stop key is
pressed during operation and then flashes STP2.
The PLC must send a Stop command followed by a Run
command to the iDrive for it to be restarted.
The iDrive will decelerate to stop and then flashes E.S. when
there is an external emergency stop signal via the
multi-function input terminals (see descriptions of b35 ~ b38).
The iDrive stops immediately and then flashes b.b. when
external base block is input through the multi-functional input
terminal (see descriptions of b35 ~ b38).
PID feedback signal circuit error detection
1. REMOTE KEYPAD is not connected with inverter, such a
display will occur.
2. REMOTE KEYPAD and main KEYPAD both display such
signal means a communication error.
Note: It is normal for the main iDrive keypad to display this
code when the REMOTE KEYPAD is connected and
functioning normally
5-4
Chapter 5 Trouble shooting and maintenance
Description