Function Parameters - IMO iDrive2 XKL Instruction Manual

iDrive2 inverters

5 Function Parameters

The function parameters of iDrive2 XKL series inverters have been divided into 30 groups (P00~P29) according to
the function, of which P18~P28 are reserved. Each function group contains certain function codes applying 3-level
menus. For example, "P08.08" means the eighth function code in the P8 group function, P29 group is factory
reserved, and users are unable to access these parameters.
For simplicity of function codes setting, the function group number corresponds to the first level menu, the function
code corresponds to the second level menu and the function code corresponds to the third level menu.
Parameter Menu.
Menu Sub Menu
P00 P00.00 – P00.18
P01 P01.00 – P01.24
P02 P02.00 – P02.27
P04 P04.00 – P04.24
P05 P05.00 – P05.41
P06 P06.00 – P06.21
P07 P07.00 – P07.56
P08 P08.00 – P08.50
P09 P09.00 – P09.13
P10 P10.00 – P10.32
P11 P11.00 – P11.13
P14 P14.00 – P14.06
P17 P17.00 – P17.37
1. Below is the instruction of the function lists:
The first column "Function code": code of function parameter group and parameters；
The second column "Name": full name of function parameters；
The third column "Detailed illustration of parameters": Detailed explanation of the function parameters
The fourth column "Default value": the original factory set value of the function parameter；
The fifth column "Modify": shows the modification ability of the parameter according to the list:-
"○": means the set value of the parameter can be modified in stop and running state；
"◎": means the set value of the parameter can only be modified in stop state；
"●": means the value of the parameter is the real detection value which can not be modified.
Function
Name
code
Speed
P00.00
control mode
Description
Basic parameters
Start/Stop control
Motor 1 settings
V/F control
Input terminals
Output terminals
Keypad/HMI settings
Enhanced functions
PID control settings
Pre-set speeds & PLC
Protective functions
Comms settings
Monitoring
Detailed instruction of parameters
P00 Group Basic function group
2:PWM control (suitable for AM)
2 is suitable in cases where it does not need high control
accuracy, such as the load of fan and pump. One
inverter can drive multiple motors.
Examples of Functions
Run command type, Max frequency, ramp times
DC injection braking, coast to stop, delay start, auto restart
Motor ratings, Kw, Current, speed
Torque boost, slip compensation, V/F curve
Set function of digital inputs S1-S5
Set function of relay, transistor and analogue outputs
Set user password, quick key function and display
Jogging, cooling fan and dynamic braking functions
PID, SV and feedback source settings
Pre-set speed values & PLC selection
Set protective function trip/output levels
Baud rate, check bits and other Modbus/RS485 settings
Monitor live values of inverter during operation
22
Function Parameters
Default
Modify
value
2
◎