Chapter 3 Operation Using The Keypad; Keys, Potentiometer, And Led On The Keypad - IMO Jaguar CUB Instruction Manual

Chapter 3 OPERATION USING THE KEYPAD

3.1 Keys, Potentiometer, and LED on the Keypad

As shown in the figure at right, the
keypad consists of a four-digit LED
monitor, a potentiometer (POT), and
six keys.
The keypad allows you to start and
stop the motor, monitor running
status, and switch to the menu mode.
In the menu mode, you may set the
function code data, monitor I/O signal
states, maintenance information, and
alarm information.
Table 3.1 Overview of Keypad Functions
Monitor,
Potentiometer
and Keys
Four-digit, 7-segment LED monitor which displays the following according to the
operation modes *.
In Running mode:
In Programming mode: Menus, function codes and their data
In Alarm mode:
Potentiometer (POT) which is used to manually set frequency, auxiliary fre-
quencies 1 and 2 or PID process command.
RUN key. Press this key to run the motor.
STOP key. Press this key to stop the motor.
UP/DOWN keys. Press these keys to select the setting items and change the
/
function data displayed on the LED monitor.
Program/Reset key which switches the operation modes* of the inverter.
In Running mode:
In Programming mode:Pressing this key switches the inverter to Running
In Alarm mode:
Function/Data key which switches the operation you want to do in each mode as
follows:
In Running mode:
In Programming mode: Pressing this key displays the function code and sets
In Alarm mode:
* Jaguar CUB features three operation modes--Running, Programming, and Alarm modes. Refer to Section
3.2 "Overview of Operation Modes."
Program/Reset key LED monitor
Function/Data key Down key Up key
Functions
Running status information (e.g., output frequency,
current, and voltage)
Alarm code which identifies the error factor if the
protective function is activated.
Pressing this key switches the inverter to Program-
ming mode.
mode.
Pressing this key after removing the error factor will
switch the inverter to Running mode.
Pressing this key switches the information displayed
(output frequency (Hz), current (Amps) or voltage
(V)).
the data entered with the and
Pressing this key displays information concerning the
alarm code currently displayed on the LED monitor.
3-1
RUN key Potentiometer
STOP key
keys or the POT.