Ipv6 Multicast Status - ZyXEL Communications MGS3520 Series User Manual

The following table describes the labels in this screen.
Table 86 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering
Profile
LABEL
Profile Name
Start Address
End Address
Add
Clear
Profile Name
Start Address
End Address
Delete
Cancel

25.4 IPv6 Multicast Status

Click Advanced Application > Multicast > IPv6 Multicast to display the screen as shown. This
screen shows the IPv6 multicast group information. See
information on multicasting.
Figure 118 Advanced Application > Multicast > IPv6 Multicast
The following table describes the fields in the above screen.
Table 87 Advanced Application > Multicast > IPv6 Multicast
LABEL
Index
VID
Port
Chapter 25 Multicast
DESCRIPTION
Enter a descriptive name for the profile for identification purposes.
To configure additional rule(s) for a profile that you have already added, enter the profile
name and specify a different IP multicast address range.
Type the starting multicast IP address for a range of multicast IP addresses that you want
to belong to the IGMP filter profile.
Type the ending multicast IP address for a range of IP addresses that you want to belong
to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Start Address and
End Address fields.
Click Add to save the profile to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
This field displays the descriptive name of the profile.
This field displays the start of the multicast address range.
This field displays the end of the multicast address range.
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want
to remove in the Delete Profile column, then click the Delete button.
To delete a rule(s) from a profile, select the rule(s) that you want to remove in the Delete
Rule column, then click the Delete button.
Click Cancel to clear the Delete Profile/Delete Rule check boxes.
DESCRIPTION
This is the index number of the entry.
This field displays the multicast VLAN ID.
This field displays the port number that belongs to the multicast group.
MGS3520 Series User's Guide
208
Section 25.1 on page 200 for more