Seat; Steering Wheel - MacDon 9000 Operator's Manual

OPERATOR'S STATION
Seat
OPERATOR WEIGHT ADJUSTMENT
There is a graduated scale on the front of the seat
frame. Turn crank (A) clock-wise to increase
suspension stiffness.
SEAT FORE-AFT POSmON
To adjust, pull out on lever (B), move seat forward
or rearward to desired position and release lever.
SEAT HEIGHT
To adjust:
1. Tilt steering wheel forward.
2. Standing in front of seat facing rearward, grasp
seat-bottom near the back and pull up.
3. There are three height positions. Lifting from the
lowest position, seat stop will "click-in" at middle
position. Lifting further, stop will •click-in" again
at the highest position. Lifting past the highest
position allows return to the lowest position.
SEAT-BOTTOM ANGLE
The seat-bottom has three angle positions. Rotate
knob (C) clockwise to raise front of seat cushion.
SEAT-BACK ANGLE
Pull up on lever (D), position seat-back as desired,
and release lever.
LUMBAR SUPPORT
Rotate knob (E) to position lumbar support as
desired.
ARM REST
Arm rest has two positions, vertical and horizontal.
Raise left hand arm rest when leaving seat for
easier exit and re-entry.
Steering Wheel
To adjust steering wheel tilt:
1. Pull handle (F) towards seat to loosen steering
column pivot.
2. Move steering wheel to desired position.
3. Push handle forward to lock the position.
NOTE:
The travel arc of handle
(F)
can be
repositioned as follows:
1. Loosen the handle 4 or 5 turns.
2. Reposition the head of carriage bolt (G) in
square hole. (Index the bolt head in the opposite
direction you want travel arc to move.)
3. Tighten handle.
23
SEAT ADJUSTMENTS
STEERING WHEEL