Selecting Gp-Ib Communications And Setting The Gp-Ib Address - YOKOGAWA TA220 User Manual

8.4 Selecting GP-IB Communications and Setting
the GP-IB Address
Procedure
KEY
LOCK SEC RANGE
Explanation
IM 704610-01E
Display 2 Display 1
ns ms s % V
%/
S
1. Press SHIFT+ENTER (UTILITY). The Utility menu is shown on Display 2.
2. Turn the rotary knob to display Netwrk in Display 2.
3. Press >. Device, GPIBadd, DHCP, IP add1, IP add2, IP add3, IP add4,
NetMsk1, NetMsk2, NetMsk3, NetMsk4, Gatewy1, Gatewy2, Gatewy3,
Gatewy4, MACadd1, MACadd2, MACadd3, or Timeout is displayed.
Selecting GP-IB Communications
4. Turn the rotary knob to select Device.
5. Press > (or ENTER). Display 1 blinks.
6. Turn the rotary knob to select GPib.
7. Press ENTER.
Setting the GP-IB Address
4. Turn the rotary knob to select GPIBadd.
5. Press > (or ENTER). Display 1 blinks.
6. Use rotary knob & < > to set the GP-IB address.
7. Press ENTER.
GP-IB Communication
The instrument can be controlled using communication commands sent from a PC or
other controller device via the GP-IB interface.
GP-IB Address
When connecting via GP-IB, each device has its own unique system-internal GP-IB
address. This address is used to differentiate the devices. When connecting the TA220
to a PC or other device, you must specify a GP-IB address for the TA220. The available
setting range is 0 to 30.
L.MARK R.MARK
DISP OFF
MEASURE
E2T
JUDGE
PW
GO
BD x1 D to C
NO-GO GATE TIME DELAY BLOCK
MEDIA FUNCTION ARMING INHIBIT
SHIFT SHIFT REMOTE STORE UTILITY
10%
LOCAL RECALL ENTER
20%
JDG LEVEL LEVEL COUPLE EQ BOOST
S
POLARITY TRIG IMPEDANCE EQUALIZER
AUTO MAN 50 Ω 1M Ω CONV
SEC RANGE
SCALE
The phrase, "rotary knob & <>"
is used in the following
explanation to instruct the user
to enter numerical setting values
using the knob and arrow keys.
For details on this procedure,
see section 3.7.
8-5
8