3.1.2
Setting of the number of transmission points, double check
mode, and waveform output method
Set the number of transmission points, double check mode, and waveform output method using "Switch 1", "Switch 3
", and "Switch 4" of "Switch setting for I/O and intelligent function module".
Double-click the "PLC Parameter" in the Project window of the programming tool, and perform the following
operations.
• Click the "I/O Assignment" tab.
• Click the "Switch Setting" button.
• Open the "Switch Setting for I/O and Intelligent Function Module" window.
• Set a value to "Switch 1", "Switch 3", and "Switch 4".
"Q Parameter Setting" window
28
Double-click this item.
Click this button.