Dscp-To-Ieee 802.1P Priority Settings - ZyXEL Communications XMG1930-30 User Manual

30-port multi-gigabit smart managed layer-2 switch, 30-port multi-gigabit smart managed layer-2 poe switch
Table of Contents

Advertisement

Figure 231 SWITCHING > QoS > Diffserv
The following table describes the labels in this screen.
Table 171 SWITCHING > QoS > Diffserv
LABEL
Active
Port
*
Active
Apply
Cancel

48.3 DSCP-to-IEEE 802.1p Priority Settings

You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to prioritize all traffic based on
the incoming DSCP value according to the DiffServ to IEEE 802.1p mapping table.
The following table shows the default DSCP-to-IEEE802.1p mapping.
Table 172 Default DSCP-IEEE 802.1p Mapping
DSCP VALUE
IEEE 802.1p
Chapter 48 Differentiated Services
DESCRIPTION
Enable the switch button to enable Diffserv on the Switch.
This field displays the index number of a port on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set the
common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select Active to enable Diffserv on the port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
0 – 7
8 – 15
16 – 23
0
1
2
XMG1930 Series User's Guide
24 – 31
32 – 39
40 – 47
3
4
5
335
48 – 55
56 – 63
6
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xmg1930 series

Table of Contents